Skip to main content

Travan 40 IDE Tape Drive Jumper Settings

There are four jumpers to the left of the 40-pin IDE Interface. The jumper that is the closest to the IDE Connector is Jumper 4. When Jumper 4 is jumped, the Device is set to Master. When the jumper is unjumped, the Device is set to Slave. The jumper to the left of Jumper 4 is Jumper 3. When only Jumper 3 is jumped, the Device is set to Cable Select. I recommend that the Travan 40 IDE Tape Drive be set as the Master. If there is a CDROM drive, it would then be set as Slave.

Please Note: In the BIOS of the Computer, the Drive Configuration Setting must be enabled that allows the CDROM and the Travan40 tape drive to be properly detected. You may need to change this setting to Auto for the appropriate IDE channels. Also the Boot Order may need to be the following in order to avoid any error messages:

  • Cerc
  • IDE Drive
  • SATA Drive
  • CDROM
  • Floppy
Labels:

Comments

Post a Comment

Popular posts from this blog

Access Denied (policy_denied). Your system policy has denied access to the requested URL. For assistance, contact your network support team.

While browsing the internet, you may encounter the message: "Access Denied (policy_denied).  Your system policy has denied access to the requested URL.  For assistance, contact your network support team."   This message indicates the internet traffic is being filtered.  The most common source of an internet traffic filter is in corporate environments that use a proxy server or a firewall appliance designed to filter web traffic.  Some businesses are configured as satellite locations using a VPN tunnel.  In these configurations, the VPN may be configured to filter internet traffic.  In rare instances, the Internet Service Provider is filtering internet traffic.  Typically though, your IT Department or a Network Management Team has configured your internet traffic to be filtered.  Isolating Source of Web Filtering In an environment that is unmanaged and the source of the filtering is unknown, following are some steps you may wish to peform: Th...
3 comments
Read more

Event ID: 7001 - Source: VSS - Unable to create a shadow copy

When using Microsoft Windows Server, you may encounter the error message: "Unable to create a shadow copy."  In the Event Viewer, you may find the following Event: "Event ID: 7001 - Source: VSS - Unable to create a shadow copy."  This event involves the Volume Shadow Copy Service (VSS).  Most likely the Server was rebooted while creating a Shadow Copy.  Many websites describe deleting or renaming the C:\WINDOWS\SYSTEM32\WBEM directory used by Windows Management Instrumentation to resolve this issue.  This is not correct.  Following are the steps to resolve this issue: Double-click My Computer. Right-mouse click the Hard Drive causing the problem. Click the Shadow Copies tab. Select the appropriate Volume. Click Disable. Click OK. Click Start - Control Panel - Administrative Tools - Scheduled Tasks. Delete all tasks related to the Volume Shadow Copy Service. Reboot the Server. Double-click My Computer. Right-mouse click the Hard Drive causing the problem. Cl...
Post a Comment
Read more

How do you stop an unstoppable Windows Service?

You may encounter a Windows Service in Services that has the buttons for Start, Stop, Pause and Resume greyed out.  If you attempt to stop the Service using sc stop [servicename], you encounter the error message: "The requested control is not valid for this service."  To resolve this issue, please perform the following steps: Click Start - Control Panel - Administrative Tools - Services. Double-click the relevant Service. Change the Service Start-Up Type to Disabled. Click Apply. Click OK. Hit CTRL-ALT-DEL on your keyboard. Select Task Manger. Perform an End Task on the relevant Service. This issue has been resolved. http://www.smartnetadmin.com
Post a Comment
Read more